01E / Fire-Rated Board Systems

Dry-application protection built to the tested board, fixing and joint detail.

Supply and installation of project-approved board and enclosure systems for structural, service and compartmentation applications.

Direct route

A controlled path from requirement to delivery.

Fire-rated boards can provide clean, dry-application protection for steel, service enclosures and compartmentation uses covered by the approved system.

Performance depends on board type and thickness, framing, fastener spacing, joints, penetrations and terminations—not the board sheet alone.

BoardSystem-specific

FixingDetail-led

FinishInspectible

01 / Buyer outcome

What this route should produce

Accurate board and framing take-off
System-matched fixing detail
Coordinated interfaces and openings
Documented inspection and handover

02 / Inputs

What Vortexen needs to qualify it

Assembly detail
Board type and thickness
Structural or service geometry
Fixing substrate
Openings and access panels
Finish requirement

01 / Scope

What the route can cover

Structural steel encasement
Service and duct enclosure where approved
Compartmentation boards
Shaft and riser interfaces
Framing and fixing systems
Joint treatment and inspection

02 / Method

How work moves forward

Review approved assembly and interfaces
Set out framing and access
Install boards and fixings to detail
Treat joints and penetrations
Inspect and record concealed work

03 / Evidence

What buyers should expect

Approved board assembly
Material traceability
Fixing and framing inspection
Photographic concealed-work records

Commercial and technical guardrails

What this route refuses to hide.

Fast progress is valuable only when assumptions, responsibility and limitations remain visible to the buyer and delivery team.

01No board-only substitution
02No unapproved fixing spacing
03No concealed joints without inspection
04No unsupported service penetrations

Frequently asked

Answers before the first meeting.

01Can any fire-rated board use the same framing?+

No. Board, framing, fasteners, spacing, joints and supports form one tested or approved assembly.

02Are access panels included?+

Only when the approved system and scope define a compatible access-panel solution.

03What should be inspected before closure?+

Framing, fixings, joints, backing, service interfaces and any concealed reinforcement or support details.

Bring the actual requirement, evidence and deadline.

Start this route ↗